High-end precision rolling imported rolling guide

The height of the guide roll is 170mm~75mm, and it is used for the entrance of the rolling mill for rough rolling, intermediate rolling and pre-finishing rolling of rods and wires. "A pair of compression springs + two adjustment wheels" adjusts the opening and closing of the support arm, thereby adjusting the opening of a pair of guide rollers; there is a wheel-type fine-tuning device, which can fine-tune the opening of the guide and guard rollers online. This adjustment is a single Point symmetrical adjustment. Guide roller bearings are lubricated with oil, gas or grease. There are cooling water holes on the support arm, spray water to cool the guide roller, and the water inlet is also on the support arm. The base and the box are separated and connected by bolts. For different guide beams, the base is different, but the box can be used in common, so that the number of spare parts can be reduced.